how to use scanmaster 2.1 for turbo buick

In the search for a better more efficient charge intake, you may want to consider the duttweiler intercooler modification. Once I switched to the tweak chip all bad manners were erased and it acted like a new Toyota Camry in traffic. It would die at times in traffic which really caused havoc in traffic. Mine had weird surging and searching in the rpm and street manners was weird. The thing you'll notice the most is that driveablility will be much better. You will have to have a reburned chip to run the alky. note: still have factory head gaskets after 23+ psi runs for the past 20+ years. Knock can ruin your day and destroy shit, but the factory knock sensor is the reason Buick could even sell these turbo cars then and it's pretty fast to pull timing for a 25 yr old set-up and save your ass (read Gale Banks comments on the sensor and developer in the new issue of HotRod magazine)īack in the early 90's I ran high boost with no monitoring gauges and went by ear to hear knock. This is where the scan master comes in to monitor any knock. You also need a adjustable fuel pressure reg, and you need to set that baby to about 42-43 psi with the cap off at idle, so that with cap on and at WOT your running about 61-63 psi to 20+psi of boost ideally, others can chime in with their experiences and opinions. Your gonna need a fuel pressure gauge either wet on the rail under hood or a fancy in cabin gauge. So if you can make that stock turbo run more efficient, the better. The stock turbo is only efficient to about 16 psi, after that it starts whipping the air up to a hotter charge. It's easy to find at hardware store if meth is hard to source.īasically keeping the intake charge efficient increases hp. This is prolly the place to get all the info i needĬlick to expand.I agree with Jarred on the the meth injection option. to smoke them or at least put up a good fight. but it would be nice when im out casually driving it.and some newer. But 3 weeks after I got it I tore my achilles tendon and was not able to get in the car. I am the 2nd owner.Īnd I am hearing I will need a scan master too. but i want a little more speed.I used to be good with cars when I was younger but its been 20 yrs since I have really done any type of mods. how much quicker will this make the the car? I want to do some bolt on's to get some quicker 0-60mph and 1/4 mile times. If I got the 60lb injectors with the chip from TweakStore.

How to use scanmaster 2.1 for turbo buick